What is the key design element in Grundfos Distributed Pumping?
What is the benefit of aligning primary side flow with secondary side flow?
Why is coil flow always correct in a distributed pumping system?
With a single dedicated pump for each terminal unit, which control mode is used?
Test results
Congratulations. You have passed the test and completed the 69 - The Grundfos Distributed Pumping Course
Achieved badges:
Q: What is the key design element in Grundfos Distributed Pumping?
A: A new kind of intelligent valve
Q: What is the key design element in Grundfos Distributed Pumping?
A: The use of intelligent pumps instead of valves
Q: What is the key design element in Grundfos Distributed Pumping?
A: Making bypass lines obsolete
Q: What is the benefit of aligning primary side flow with secondary side flow?
A: To ensure distributed pumps never miss water on the suction side
Q: What is the benefit of aligning primary side flow with secondary side flow?
A: To avoid increasing pressure in the bypass pipe
Q: What is the benefit of aligning primary side flow with secondary side flow?
A: To avoid or minimise the ‘low’ Delta T syndrome
Q: Pump energy savings in a distributed pumping system are around:
A: 25%
Q: Pump energy savings in a distributed pumping system are around:
A: 35%
Q: Pump energy savings in a distributed pumping system are around:
A: 54%
Q: Why is coil flow always correct in a distributed pumping system?
A: By using large variable speed-controlled primary pumps
Q: Why is coil flow always correct in a distributed pumping system?
A: Because Magna 3 pump speed is modulated based on terminal unit load
Q: Why is coil flow always correct in a distributed pumping system?
A: Because the system runs with maximum flow at maximum load
Q: How much flow is required to achieve almost 80 % of the capacity?
A: 50%
Q: How much flow is required to achieve almost 80 % of the capacity?
A: 30%
Q: How much flow is required to achieve almost 80 % of the capacity?
A: 80%
Q: With a single dedicated pump for each terminal unit, which control mode is used?
A: Proportional pressure
Q: With a single dedicated pump for each terminal unit, which control mode is used?
A: Proportional pressure or constant temperature – doesn’t matter
Q: With a single dedicated pump for each terminal unit, which control mode is used?
A: Constant temperature