What is well development?
Why is it a good idea to make a well where the groundwater level is as high as possible?
By-pass control is an efficient way of performance regulating a pump but what is the downside of the process?
Why is it important to know the water drawdown?
What could be the consequences of using an undersized pump in a well?
What should the minimum flow past the motor be to ensure sufficient motor cooling?
What is the most effective way to stay updated on your pump’s condition?
On top of energy-efficient pump operation, how does a frequency drive benefit your installation?
Test results
Q: What is well development?
A: The drilling of a hole in the ground to find groundwater
Q: What is well development?
A: The installation of the well casing in the centre of the borehole
Q: What is well development?
A: A process that ensures that the well’s sand filter has been improved so the well produces clean, sand-free water
Q: Why is it a good idea to make a well where the groundwater level is as high as possible?
A: The shorter the distance is to the water the less expensive it is to make the borehole and subsequently to pump the water to the surface
Q: Why is it a good idea to make a well where the groundwater level is as high as possible?
A: The shorter the distance is from the surface to the ground water, the better the water quality is
Q: Why is it a good idea to make a well where the groundwater level is as high as possible?
A: A higher level means lower water temperatures and better motor cooling
Q: By-pass control is an efficient way of performance regulating a pump but what is the downside of the process?
A: The by-passed water is wasted and cannot be used again
Q: By-pass control is an efficient way of performance regulating a pump but what is the downside of the process?
A: The motor temperature rises and increases the risk of motor burn-out
Q: By-pass control is an efficient way of performance regulating a pump but what is the downside of the process?
A: Energy is wasted as the pump continues to run at full speed
Q: Why is it important to know the water drawdown?
A: The more the drawdown increases during pump operation, the more pressure is required to lift the groundwater to the surface
Q: Why is it important to know the water drawdown?
A: Increased drawdown leads to poor water quality
Q: Why is it important to know the water drawdown?
A: Steel casings may not be used if the drawdown is too big
Q: What could be the consequences of using an undersized pump in a well?
A: The pump will give too high pressure
Q: What could be the consequences of using an undersized pump in a well?
A: The risk of cavitation is very high
Q: What could be the consequences of using an undersized pump in a well?
A: The pump may not be able to deliver the required capacity
Q: What should the minimum flow past the motor be to ensure sufficient motor cooling?
A: 0,5 m/s
Q: What should the minimum flow past the motor be to ensure sufficient motor cooling?
A: 0,15 m/s
Q: What should the minimum flow past the motor be to ensure sufficient motor cooling?
A: There are no specific requirements
Q: What is the most effective way to stay updated on your pump’s condition?
A: Manual inspection
Q: What is the most effective way to stay updated on your pump’s condition?
A: Remote online monitoring
Q: What is the most effective way to stay updated on your pump’s condition?
A: Regular maintenance
Q: On top of energy-efficient pump operation, how does a frequency drive benefit your installation?
A: It comes with a built-in motor protection
Q: On top of energy-efficient pump operation, how does a frequency drive benefit your installation?
A: It can reduce cavitation
Q: On top of energy-efficient pump operation, how does a frequency drive benefit your installation?
A: It cools the motor